Company News

How to Make a Camera Copy Stand

remote switch remote control lens hood camera screw camera lens and accessories

Update time : 2020-01-13 11:45:42

A desktop camera xerox lie is highly useful although photographing brittle documents, or although a firm lie ought cinema objects. You can vertical your cause from wood, acrylic pipe, and a little other components although a piece of the price of a commercial stand. You can easily adapt this basic design ought add lights and other accessories.

.

1) elect an acrylic pipe with a diameter slightly larger than the diameter of the wooden lie bar. although example, if the wooden lie has a diameter of one inch (2.5 cm), find an acrylic pipe with a diameter of 1.5 inches (3.8cm).

2) abbreviate a district of acrylic pipe.

Measure a district almost two inches (five centimeters) long.
Cut off that district with a saw.

3) Sand off the acrylic pipe. Sand off the edges using a lovely file. Sanding the margin will invent it easier ought slip this component.

4) elect a bolt big enough that it can impress at completely across the acrylic pipe. You'll lack a big bolt ought cause the camera lie conference at place. at our example, a bolt three inches (7.5 cm) expectation will career well.

5) signal a turn at the middle of the pipe.

6) training a hole the diameter of the bolt.

7) training a wooden rod at lay intervals. These holes will hire you ought change the altitude of your cam stand. begin with a wooden rod, ideally almost 30 inches (76cm) tall.

Fit the acrylic pipe at the wooden rod, and adapt until it is blush with one end.
Mark the wooden rod where it is exposed by the hole at the pipe.
Make additional marks at the rod at 1 inch (2.5cm) intervals from this mark, across the entire length.
Drill holes at these marks, using the too diameter although the bolt.

8) standard the diameter of the camera screw.

9) training a hole this size at the elastic pipe. The hole ought exist at accurate angles ought the bolt hole position.

The camera screw ought exist able ought attach ought your camera tripod head.

10) stick at the screw. This is the most important component, and cause ought exist mounted firmly although the camera ought linger attached.

Position the base of the camera tightly at the hole you just drilled, with the screw pointing outward.
Fix it at lay with a generous amount of gorilla stick or other robust stick that will bond ought the acrylic pipe. although best results, hire the stick dry overnight.

11) attach the extension block (optional). if your wooden rod is shorter than 30 inches (76 cm) long, slot it into another length of pipe ought rise it ought the full recommended height.

12) attach the base. The base provides back although the entire assembly. This is a square wooden plank, with dimensions 5 at x 5 at x 1 at (12.7 x 12.7 x 2.5cm).

13) training a hole the diameter of the wooden rod (one inch/2.5cm).

14) parcel the rod at tightly. Hammer it down.

15) Screw at the camera tripod head. Screw the tripod head into the camera screw.

16) quiz out your new camera xerox stand. ought use the xerox stand, just impress the acrylic pipe ought the desired altitude and screw at the bolt. attach the camera, and you're ready ought shoot.

Previous : How to Attach a Camera to a Tripod

Next : How to Clean a 35mm Film Camera and Lens